SER MGT Port

The SER MGT port is an RJ-45 connector that provides RS-232 access to the SEFOS and Oracle ILOM CLI interfaces running on the SP. The port is located at the lower-left corner of the switch front panel. See Cable Connections (Oracle Switch ES2-72) or Cable Connections (Oracle Switch ES2-64).

The serial device must be configured to these parameters:

• 9600 baud (default, can be set to any standard rate up to 115200)

• 8N1 — eight data bits, no parity, one stop bit

• Software flow control (XON/XOFF) disabled

The figure and table describe the pinouts of the SER MGT connector.

Pin Signal Description 1 Request To Send (RTS) 2 Data Terminal Ready (DTR) 3 Transmit Data (TXD) 4 Ground 5 Ground 6 Receive Data (RXD) 7 Data Set Ready (DSR) 8 Clear To Send (CTS)

Related Information

• Management Connection Overview

• NET MGT Port

• Cable Connections (Oracle Switch ES2-64)

• Connect Data Cables