Default Configuration
Values
By default, OSPFv3 and IPv6 addressing are disabled on a switch
running SEFOS. To configure an OSPFv3 router or to configure an
interface with an IPv6 address, you must first enable OSPFv3 or
IPv6 on the interfaces.
|
|
ABR-type |
Standard |
Area default-cost |
10 |
Area metric value |
1 |
Area type |
Transit |
AS-external LSDB-limit |
-1 (no limit) |
Dead-interval |
40 |
Default network type |
Broadcast |
Default OSPFv3 trace level |
Critical (If enabled) |
Default-information originate always metric |
10 |
Default-information originate always metric-type |
2 |
Demand circuit |
Enabled |
Exit overflow interval |
0 |
Hello-interval |
10 |
IETF non-stop forwarding |
Disabled |
IETF NSF helper strict LSA check |
Disabled |
IETF NSF helper support unknown/s/w restart/s/w
upgrade/ switch to redundant |
Enabled |
Interface metric |
From the reference bandwidth |
IPv6 on the interface |
Disabled |
Neighbor-probe retransmit - interval |
120 |
Neighbor-probe retransmit-limit |
10 |
nssa asbr-default-route translator |
Disabled |
OSPFv3 module on the router |
Disabled |
OSPFv3 traces |
Disabled |
Passive interface |
Disabled |
Poll-interval |
120 |
Redist-config metric-type |
Type-2 |
Redist-config metric-value |
10 |
Redist-config tag |
0 |
Reference bandwidth |
100000 |
Retransmit-interval |
5 |
Route calculation staggering |
Enabled |
Router priority |
1 |
SPF hold time |
10 |
SPF timer delay |
5 |
Stability interval |
40 |
Staggering interval |
10 |
Summary-address |
Advertise |
Translation |
Enabled |
Translation-role |
Candidate |
Transmit-delay |
1 |
|