Configure SEFOS2

Use the following commands and values to configure the VLAN interfaces in SEFOS2 used in the example topologies presented in this guide (VLAN 11 and VLAN 2).

• Type.

  SEFOS# configure terminal
  SEFOS(config)# interface vlan 11
  SEFOS(config-if)# shut
  SEFOS(config-if)# ipv6 enable
  SEFOS(config-if)# ipv6 address  fec0::1111:0:1/96
  SEFOS(config-if)#  no shut
  SEFOS(config-if)# exit
  SEFOS(config)# interface vlan 2
  SEFOS(config-if)# shut
  SEFOS(config-if)# ipv6 enable
  SEFOS(config-if)# ipv6 address fec0::2556:0:1/96
  SEFOS(config-if)# no shut
  SEFOS(config-if)# exit