dact-ee

Use this command to deactivate an Eagle Eyes Card and stop capturing traffic on it. The state of the card is changed from ACT (Active) to DACT (Deactivated).

Note:

If the card boots, then the status of the card would be reset to DACT. This will clear the EE configuration from the card.

Parameters

loc (mandatory)

The Eagle Eyes card location as stenciled on the shelf of the system.

Range:: 1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

dact-ee:loc=1203

Dependencies

The card at the specified location must be equipped.

The card should be configured as an Eagle Eyes card.

Notes

The value specified for the loc parameter must refer to a card running one of the following GPLs, and the referenced card must be equipped:

IPSG, IPLHC, IPGHC
ATMHC
SS7HC
SIPHC
DEIRHC
ERTHC

Output

dact-ee:loc=1101


Command Accepted - Processing

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
dact-ee:loc=1101
Command entered at terminal #1.
;


tekelecstp 11-08-16 18:35:44 MST UNKNOWN EAGLE 46.0.0 
Deactivate EE message sent to card. 
;

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
Command Completed.
;