dact-gedti

Use this command to deactivate a GEDTI Hub. The state of the GEDTI Hub is changed from ACT (Active) to DACT (Deactivated).

Note:

The specified card must be Active before the command can be executed. If the card boots, then the status of the GEDTI Hub will be reset to DACT.

Parameters

loc (mandatory)

The card location as stenciled on the shelf of the system.

Range:: 1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118, 1113, 1115

Example

dact-gedti:loc=1102

Dependencies

The value specified for the loc parameter must refer to an equipped card location.

A valid value must be specified for the loc parameter.

The card at the specified location must be configured as a GEDTI Hub.

Deactivating the state of a GEDTI Hub that is already deactivated has no effect.

Notes

None.

Output

dact-gedti:loc=1101


Command Accepted - Processing

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
dact-gedti:loc=1101
Command entered at terminal #1.
; 

tekelecstp 11-08-16 18:35:44 MST UNKNOWN EAGLE 46.0.0 
Deactivate GEDTI Hub message sent to card. 
;

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
Command Completed.;