5.12 dact-ee
Use this command to deactivate an Eagle Eyes Card and stop capturing traffic on it. The state of the card is changed from ACT (Active) to DACT (Deactivated).
Note:
If the card boots, then the status of the card would be reset to DACT. This will clear the EE configuration from the card.Parameters
- loc (mandatory)
- The Eagle Eyes card location as stenciled on the shelf of the system.
- Range:
- 1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118
Example
dact-ee:loc=1203
Dependencies
The card at the specified location must be equipped.
2101 E2101 Cmd Rej: Card location is unequipped
The card should be configured as an Eagle Eyes card.
2984 E2984 Cmd Rej: Eagle Eyes not configured on the card
Notes
The value specified for the loc parameter must refer to a card running one of the following GPLs, and the referenced card must be equipped:
- IPSG, IPLHC, IPGHC
- ATMHC
- SS7HC
- SIPHC
- DEIRHC
- ERTHC
Output
dact-ee:loc=1101
Command Accepted - Processing
tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0
dact-ee:loc=1101
Command entered at terminal #1.
;
tekelecstp 11-08-16 18:35:44 MST UNKNOWN EAGLE 46.0.0
Deactivate EE message sent to card.
;
tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0
Command Completed.
;
Related Topics