5.13 dact-gedti

Use this command to deactivate a GEDTI Hub. The state of the GEDTI Hub is changed from ACT (Active) to DACT (Deactivated).

Note:

The specified card must be Active before the command can be executed. If the card boots, then the status of the GEDTI Hub will be reset to DACT.

Parameters

loc (mandatory)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118, 1113, 1115

Example

dact-gedti:loc=1102

Dependencies

The value specified for the loc parameter must refer to an equipped card location.

2101 E2101 Cmd Rej: Card location is unequipped

A valid value must be specified for the loc parameter.

2376 E2376 Cmd Rej: Specified LOC is invalid

The card at the specified location must be configured as a GEDTI Hub.

2144 E2144 Cmd Rej: Location invalid for hardware configuration

Deactivating the state of a GEDTI Hub that is already deactivated has no effect.

3827 E3827 Cmd Rej: No change requested

Notes

None.

Output

dact-gedti:loc=1101

Command Accepted - Processing

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
dact-gedti:loc=1101
Command entered at terminal #1.
; 

tekelecstp 11-08-16 18:35:44 MST UNKNOWN EAGLE 46.0.0 
Deactivate GEDTI Hub message sent to card. 
;

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 
Command Completed.;