5.7 chg-gedti-card

Use this command to configure GEDTI Hub for Eagle Eyes traffic capture.

Parameters

loc (mandatory)
IPSM Card location to be configured as GEDTI Hub.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118
port (mandatory)
GEDTI Port to be set.
Range:
1025 - 65354

Example

chg-gedti-card:loc=1211:port=1124

Dependencies

The value specified for the loc parameter must correspond to the location of an IPSM card.

2144 E2144 Cmd Rej: Location invalid for hardware configuration

The value specified for the port parameter must not be configured on any other IPSM card.

2975 E2975 Cmd Rej: Specified Port is not supported

If the GEDTI Hub is in ACTIVE state then port cannot be changed.

3726 E3726 Cmd Rej: Active device state does not permit database change

The EE Card table must be accessible.

2867 E2867 Cmd Rej: Unable to read EE Card table

Notes

None.

Output

chg-gedti-card:loc=1211:port=1245


tekelecstp 10-03-08 14:43:31 EST EAGLE 46.0.0 
EE CARD table is (2 of 256) 1% full 
CHG-GEDTI-CARD:MASP A - COMPLTD ;