5.1 act-gedti

Use this command to activate a GEDTI Hub for Eagle Eyes. The state of the GEDTI Hub is changed from DACT(Deactivated) to ACT(Active).

Note:

The GEDTI hub must be Deactived on the specified card before the command can be executed. If the card boots, then the status of the GEDTI Hub will be reset to DACT.

Parameters

loc (mandatory)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

act-gedti:loc=1102

Dependencies

The value specified for the loc parameter must refer to an equipped card location.

2101 E2101 Cmd Rej: Card location is unequipped.

The card at the specified location must be configured as GEDTI Hub.

2144 E2144 Cmd Rej: Location invalid for hardware configuration

Activating the state of GEDTI Hub that is already activated has no effect.

3827 E3827 Cmd Rej: No change requested

The card at the specified location must not be a reserved location.

2154 E2154 Cmd Rej: Card slot reserved by system

Notes

None.

Output

act-gedti:loc=1101

Command Accepted - Processing

tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0 act-gedti:loc=1101
Command entered at terminal #1.; 

tekelecstp 11-08-16 18:35:44 MST
UNKNOWN EAGLE 46.0.0 Activate GEDTI Hub message sent to card.;


tekelecstp 11-08-16 18:35:44 MST EAGLE 46.0.0
Command Completed.;