Configure an Access Port

1. Disable GVRP on the port.

   Per-port GVRP must be disabled before configuring as access mode.

   TOR-1 SEFOS# configure terminal
   TOR-1 SEFOS(config)# set port gvrp extreme-ethernet 0/1 disable
   TOR-1 SEFOS(config)#

2. Enter the configuration mode for the interface.

   TOR-1 SEFOS(config)# interface  extreme-ethernet 0/1
   TOR-1 SEFOS(config-if)#

3. Set the switchport mode.

   SEFOS(config-if)# switchport acceptable-frame-type   untaggedAndPrioritytagged
   SEFOS(config-if)# switchport mode access
   SEFOS(config-if)# end
   TOR-1 SEFOS#

   After you configure the port as access, the port becomes a member port of the VLAN that is configured as PVID for that port.