Configure the Rendezvous Point Threshold

Configuring PIMv6 rendezvous point threshold specifies the threshold at which RP initiates switching to the source-specific SPT.

1. Enable PIMv6.

   SEFOS# configure terminal
   SEFOS(config)# set ipv6 enable
   SEFOS(config)# end
   

2. Set the rendezvous point threshold to 10 seconds.

   SEFOS# configure terminal
   SEFOS(config)# set ip pim rp-threshold 5
   SEFOS(config)# end
   

3. Review the rendezvous point threshold value.

   SEFOS# show ipv6 pim thresholds
    
   PIM SPT Threshold Information
   -----------------------------
     Group Threshold  : 0
     Source Threshold : 0
     Switching Period : 0
    
   PIM SPT-RP Threshold Information
   --------------------------------
     Register Threshold       : 10
     RP Switching Period      : 0
     Register Stop rate limit : 5