Delay LAN Message Propagation

This example delays messages from VLAN 5 before sending them to the interface for 120 seconds.

1. Enable PIM globally.

   SEFOS# configure terminal
   SEFOS(config)# set ip pim enable
   

2. Enter Interface Configuration mode for the interface.

   SEFOS(config)# interface vlan 5
   

3. Associate the VLAN interface with the PIM component.

   SEFOS(config-if)# ip pim componentId 1
   

4. Specify how often (in seconds) the switch sends PIM messages to the interface.

   SEFOS(config-if)# ip pim query-interval 60
   

5. Specify how many seconds message propagation is delayed.

   SEFOS# ip pim lan-delay 120
   SEFOS(config-if)# end
   

6. Ensure that the correct interval is set.

   SEFOS# show ip pim interface detail
    
   Vlan5 33 is up
     Internet Address is 10.1.0.1
     Muticast Switching : Enabled
     PIM : Enabled
     PIMv6 : Disabled
       PIM version : 2, mode: Sparse
       PIM DR : 10.1.0.1
       PIM DR Priority : 1
       PIM Neighbour Count : 0
       PIM Hello/Query Interval : 60
       PIM Message Interval : 60
       PIM Override Interval : 0
       PIM Lan Delay : 120
       PIM Lan-Prune-Delay : Disabled
       PIM Component Id : 1
       PIM domain border : disabled