Enable PMBR Status Reporting

PMBR status reporting is disabled by default.

This example enables PMBR status for VLAN 5. In addition, the PIM component is configured in the router as component 1.

1. Enable the PMBR status feature.

   SEFOS# configure terminal
   SEFOS(config)# set ip pim enable
   SEFOS(config)# set ip pim pmbr enable
   

2. Associate the interface with PIM component 1.

   SEFOS# interface vlan 5
   SEFOS(config-if)# ip pim componentId 1
   SEFOS(config-if)# end
   

3. View the PMBR status.

   SEFOS# show ip pim interface detail
    
   Vlan5 33 is up
     Internet Address is 10.1.0.1
     Muticast Switching : Enabled
     PIM : Enabled
     PIMv6 : Disabled
       PIM version : 2, mode: Sparse
       PIM DR : 10.1.0.1
       PIM DR Priority : 1
       PIM Neighbour Count : 0
       PIM Hello/Query Interval : 30
       PIM Message Interval : 60
       PIM Override Interval : 0
       PIM Lan Delay : 0
       PIM Lan-Prune-Delay : Disabled
       PIM Component Id : 1
       PIM domain border : enabled