Disable the Default Route - Sun Ethernet Fabric Operating System

Sun Ethernet Fabric Operating System

Exit Print View

» ...Documentation Home » Oracle Switch ES2-72 and Oracle Switch ES2-64 ... » Sun Ethernet Fabric Operating System » General Configurations » Configuring Interface-Specific RIP Parameters » Configuring the RIP Default Route Propagation » Disable the Default Route

Updated: July 2015

Sun Ethernet Fabric Operating System

Document Information

Using This Documentation

General Configurations

Enabling RIP on an IP Network

Configuring RIP Security

Enable RIP Security

Disable RIP Security

Configuring the RIP Packet Retransmission Interval and Retry Count

Set the RIP Packet Retransmission Interval and Retry Count

Reset the Retransmission Interval and Retry Count

Configuring RIP Neighbors

Add a RIP Neighbor

Remove a RIP Neighbor

Configuring the RIP Passive Interface

Enable the RIP Passive Interface

Disable the RIP Passive Interface

Configuring the Output Delay

Enable the Output Delay

Disable the Output Delay

Configuring Redistribution

Enable Redistribution

Test Redistribution

Disable Redistribution

Configuring the Default Metric

Set the Default Metric

Test the Default Metric

Reset the Default Metric

Managing the auto-summary Option

Disable the auto-summary Option

Enable the auto-summary Option

Configuring Interface-Specific RIP Parameters

Configuring the Debug Level for RIP

Language:

Disable the Default Route

Enter the configuration mode for the interface.

SEFOS# configure terminal
SEFOS(config)# interface vlan 1

Disable the default route.

SEFOS(config-if)# no ip rip default route originate

Copyright © 2010, 2015, Oracle and/or its affiliates. All rights reserved. Legal Notices