| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Switch ES1-24 Configuration Guide |
Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Enable or Disable the Timeout for Line Connections
Configure the Default IP Address
Configure the IP Address for an Interface
Configure the Name of the Configuration File
Enable or Disable Trap Generation on an Interface
Save the Configuration to a File
Copy a Configuration File to a Remote Location
Copy a Configuration File From a Remote Location to Flash
Copy a Configuration File From One Remote Location or Flash to Another Remote Location or Flash
Configuring the Switching Feature
Configuring the Routing Feature
Configure Static Unicast Route Entries
This task describes how to write the system logs to a remote location. The remote location must be a host on one of the 24 ports on the switch.
In this task, you first execute several commands to customize system logs. You also clear the system buffers so that the log file can be copied over to the remote site.
See Connect to SEFOS.
SEFOS# debug npapi transmission SEFOS# show debug-logging ... SEFOS# configure terminal SEFOS(config)# clear logs SEFOS(config)# end SEFOS# SEFOS-1# copy logs tftp://12.0.0.100/logfile % Log Upload Successful SEFOS# SEFOS# no debug npapi transmission SEFOS# SEFOS# show debugging
Note - Ensure that you type the no debug npapi transmission command as shown so that the debugging function is disabled.
|