Data Cable Cautions - Oracle Switch ES1-24 Documentation

Skip Navigation Links
Exit Print View
	Oracle Switch ES1-24 Documentation

Oracle Technology Network

Document Information

Using This Documention

Related Documentation

CLI Command Modes

Support and Accessibility

Understanding the Installation

Installation Task Overview

Front Panel Components

Rear Panel Components

Confirming Specifications

Physical Specifications

Electrical Specifications

Environmental Specifications

Understanding Cabling

Understanding Management and Power Cabling

Management Connection Overview

Power Cord Specifications

Understanding Data Cabling

SFP+ Data Cable Overview

10GBASE-T Data Cable Overview

Data Cable Cautions

Data Cable Guidelines

Single-Switch Location Guidelines

Preparing for Installation

ESD Precautions

Tools Needed for Installation

Verify Switch Kit Contents

Verify Rack Rail Kit Contents

Assemble an SFP+ Data Cable

Installing the Switch

Assemble a Filler

Attach the Rails to the Switch

Attach Telco Adapters to the Rack Slides

Attach the Rack Slides to the Rack

Install the Switch Into the Rack

Attach Power Cords

Install the Air Duct and Front Support

Attach Data and Management Cables

Prepare the Front Support and Small Air Duct

Powering On the Switch

Power On the Switch

Oracle ILOM Overview

Verify the DHCP-Assigned IP Address and Host Name

Configure Network Management From the CLI (SER MGT)

Log Into the Oracle ILOM Web (NET MGT)

Log Into the Oracle ILOM CLI (NET MGT)

Log Into the Oracle ILOM CLI (SER MGT)

Administering the Switch

Log In to the Oracle ILOM CLI

Create a SEFOS User

Change a SEFOS User Privilege Level

Configure Network Management From the Web Interface

Configure Network Management From the CLI

Log Out of the Oracle ILOM CLI

Update the Firmware

Administering SEFOS

SEFOS Setup Tasks

Understanding SEFOS Basics

Configuring the SEFOS Environment

Managing Configuration Files

Managing Log Files

Configuring the Switching Feature

Switching Feature Topology

Configure Initial Settings

Verify the Configuration

Configure VLAN Forwarding

Verify VLAN Membership

Save a Configuration

Configuring the Routing Feature

Routing Feature Topology

Configuring Static Routing

Configuring Dynamic Routing

Disabling Routing

Detecting and Managing Faults

Front Panel LEDs

Rear Panel LEDs

Check Switch Status (LEDs)

Sensors Overview

Check Switch Status (Oracle ILOM)

Component Sensor Targets

Motherboard Sensor Targets

Preparing for Service

ESD Precautions

Tools Needed for Service

Replaceable Components

Remove the Front Support and Air Duct

Install the CMA

Servicing Power Supplies

Power Off a Power Supply

Remove a Power Supply

Install a Power Supply

Power On a Power Supply

Servicing the Fan Module

Remove the Fan Module

Install the Fan Module

Data Cable Cautions

Caution

Caution - Data cables with laser transceivers must be Class I.

	Do not step on the cable or connectors. Plan cable paths away from foot traffic or rolling loads.
	Do not pull the cable out of the shipping box, through any opening, or around any corners. Unroll the cable as you lay it down and move it through turns.
	Do not bend the cables to a radius tighter than 85 mm (3.4 inches). Ensure that cable turns are as wide as possible.
	Do not pack the cable to fit a tight space. Use an alternative cable route.
	Do not drop the cable or connectors from any height. Gently set the cable down, resting the cable connectors on a stable surface.
	Do not drag the cable or its connectors over any surface. Carry the entire cable to and from the points of connection.
	Do not force the cable connector into the receptacle by pushing on the cable. Apply connection or disconnection forces at the connector only.

Related Information

Copyright © 2013, Oracle and/or its affiliates. All rights reserved. Legal Notices

Previous

Next