| Skip Navigation Links | |
| Exit Print View | |
|
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
| Skip Navigation Links | |
| Exit Print View | |
|
|
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
Configuring the Topology Example
Enable IPv6 Support and Assign IPv6 Addresses
Configure the Group and Source Thresholds
Configure the SPT Switching Period
Configure the Rendezvous Point Threshold
Configure the RP Switch Period
Configuring PIMv6 on an Interface
Associate the PIMv6 Component to an Interface
Configure the Query-Interval Value
Configure the DR Priority Value
Configure the Override Interval
Configure the Message Interval
Configuring the PIMv6 Component
Set the Mode for the PIMv6 Component
Configure the RP-Candidate Hold Time
Configure the RP-Candidate Address
A register-stop message avoids the encapsulation of multicast data packets from the first-hop router to the RP. Configuring the regstop rate limit specifies the time interval between two successive register-stop messages sent by an RP.
SEFOS# configure terminal SEFOS(config)# set ipv6 pim enable
SEFOS(config)# set ip pim regstop-ratelimit-period 10 SEFOS(config)# end
SEFOS# show ipv6 pim thresholds PIM SPT Threshold Information ----------------------------- Group Threshold : 0 Source Threshold : 0 Switching Period : 0 PIM SPT-RP Threshold Information -------------------------------- Register Threshold : 10 RP Switching Period : 15 Register Stop rate limit : 10
|