Configure the RP Switch Period

Configuring PIMv6 RP switch period specifies the period (in seconds) over which the RP monitors register packets for switching to the source-specific SPT. The received packets should exceed the RP threshold within the RP switch period for switching to the source-specific SPT.

1. Set the SPT group threshold to 10 packets and the source threshold to 15 packets.

   SEFOS# configure terminal
   SEFOS(config)# set ip pim rp-threshold 10
   SEFOS(config)# end

2. Set the RP switch period to 15 seconds.

   SEFOS# configure terminal
   SEFOS(config)# set ip pim rp-switchperiod 15
   SEFOS(config)# end

3. Review the RP switch period values.

   SEFOS# show ipv6 pim thresholds
    
   PIM SPT Threshold Information
   -----------------------------
     Group Threshold  : 0
     Source Threshold : 0
     Switching Period : 0
    
   PIM SPT-RP Threshold Information
   --------------------------------
     Register Threshold       : 10
     RP Switching Period      : 15
     Register Stop rate limit : 5