Debug HA for DHCP

How to turn on debug for HA for DHCP

The /opt/SUNWscdhc/etc/config file allows you to turn on debug for a DHCP instance on a particular node within the cluster. If you require debug to be turned on for HA for DHCP across the whole cluster, repeat this step on all nodes within the cluster.

1. Edit /etc/syslog.conf and change daemon.notice to daemon.debug.

   # grep daemon /etc/syslog.conf
   *.err;kern.debug;daemon.notice;mail.crit        /var/adm/messages
   *.alert;kern.err;daemon.err                     operator
   #

   Change the daemon.notice to daemon.debug and restart syslogd. Note that the output below, from grep daemon /etc/syslog.conf, shows that daemon.debug has been set.

   # grep daemon /etc/syslog.conf
   *.err;kern.debug;daemon.debug;mail.crit        /var/adm/messages
   *.alert;kern.err;daemon.err                    operator

   Restart the syslog daemon.

   # svcadm disable system-log
   # svcadm enable system-log

2. Edit /opt/SUNWscdhc/etc/config.

   Perform this step on each node of cluster as required.

   Edit /opt/SUNWscdhc/etc/config and change DEBUG= to DEBUG=ALL or DEBUG=sun-cluster-resource.

   # cat /opt/SUNWscdhc/etc/config
   #
   # Copyright 2012 Oracle and/or its affiliates.  All rights reserved.
   #
   # ident "@(#)config     1.1     01/03/12 Oracle"
   #
   # Usage:
   #       DEBUG=<RESOURCE_NAME> or ALL
   #
   DEBUG=ALL

   ---

   Note - To turn off debug, reverse the steps above.

   ---