schedule-backup > logs-backup

The logs-backup configuration sub-element allows you to configure specific detail about when you back up your logs and support-info on the Oracle Communications Session Border Controller.

Parameters

admin-state
Enable or disable this logs backup feature. This parameter is disabled by default.
  • disabled (default)
  • enabled
retry-interval
Specifies the interval the system waits before it tries to resend a logs backup after an attempt fails.
  • Default: 5 minutes
  • Values: Min: 5 | Max: 10
retry-count
Specifies the maximum number of times the system tries to resend a logs backup after prior attempts fail.
  • Default: 3 retries
  • Values: Min: 1 | Max: 3
push-failure-alarm
Enables or disables the generation of alarms and traps in case of any push-receiver failures. This alarm is of severity type Warning.
  • Default: enabled
  • Values: enabled | disabled
support-info-interval
Specifies the number of hours between each stored support-info output. Values include:
  • Default: 3 hours
  • Values: Min: 1 | Max: 48 hours
all-logs-interval
Specifies the number of hours after which the system creates another log package. Values include:
  • Default: 12 hours
  • Values: Min: 1 | Max: 48 hours
include-all-logs
Enables the system to include all logs in each log package in addition to the support-info output. When disabled, the system only backs up the support-info output.
  • Default: disabled
  • Values: enabled | disabled
local-backups-count
Specifies the number of packaged “support-info” files to be maintained for rotation. Values include:
  • Default: 5 packages
  • Values: Min: 1 | Max: 24 packages
local-logs-backups-count
Specifies the number of packaged “all logs” files to be maintained for rotation. Values include:
  • Default: 5 packages
  • Values: Min: 1 | Max: 12 packages
local-logs-dir-size
Specifies the desired size (in MB) of the “/opt/archives/logs” folder to be maintained for storage. Values include:
  • Default: 1024 MB
  • Values: Min: 512 | Max: 2048 MB
push-receiver
Access the push-receiver sub-element.

Path

logs-backup is a subelement element of the system-config path. The full path from the topmost ACLI prompt is: configure terminal , and then system-config, and then schedule-backup, and then logs-backup.

Note:

This is a single instance configuration element.