schedule-backup > config-backup

The config-backup configuration sub-element allows you to configure specific detail about when you back up your configuration on the Oracle Communications Session Border Controller.

Parameters

admin-state
Enable or disable this configuration backup feature. This parameter is disabled by default.
  • disabled (default)
  • enabled
interval
Specifies the interval the system uses before it pushes a new backup.
  • weekly—7 days from last backup (default)
  • daily—24 hours from last backup
  • monthly—30 days from last backup
retry-interval
Specifies the interval the system waits before it tries to resend a configuration backup after an attempt fails.
  • Default: 5 minutes
  • Values: Min: 5 | Max: 30
retry-count
Specifies the maximum number of times the system tries to resend a configuration backup after prior attempts fail.
  • Default: 5 retries
  • Values: Min: 2 | Max: 10
push-failure-alarm
Enables or disables the generation of alarms and traps in case of any push-receiver failures. This alarm is of severity type Warning.
  • Default: enabled
  • Values: enabled | disabled
push-receiver
Access the push-receiver sub-element.

Path

config-backup is a subelement element of the system-config path. The full path from the topmost ACLI prompt is: configure terminal , and then system-config, and then schedule-backup, and then config-backup.

Note:

This is a single instance configuration element.