8 Configuring a Recovery Appliance Rack
This chapter describes how to configure the hardware components of a Recovery Appliance rack. It contains the following sections:
Note:
The procedures in this chapter use the files generated by Oracle Exadata Deployment Assistant. You must run this utility before doing the procedures in this chapter.
- Supporting Auto Service Request
- Installing the Tape Hardware
- Verifying the Network Configuration Prior to Configuring the Rack
Use thecheckip.shscript to ensure there are no IP address conflicts between the existing network and your new ZDLRA Rack. - Configuring the RDMA Network Fabric Switch
You must perform an initial configuration of the RDMA Network Fabric switch. - Configuring the Cisco Ethernet Switch
- Configuring the Power Distribution Units
- Checking the Health of the Compute Servers
- Checking the Health of the Storage Servers
- Verifying the RoCE Network Fabric Configuration
This procedure describes how to verify the RoCE Network Fabric configuration. - Verifying the InfiniBand Network Fabric Network
This procedure describes how to verify the InfiniBand Network Fabric network. - Setting the Subnet Manager Master on Oracle Exadata Database Machine Full Rack and Oracle Exadata Database Machine Half Rack
Parent topic: Installation and Configuration