When you duplicate a rule set, all of the information in the source rule set is copied to the new rule set. You can select whether to duplicate all the rules in the source rule set into the new rule set.

To duplicate a rule set:

1. From the Home page, select Modeling, and then Designer.

2. On the Waterfall Setup tab, click next to a rule set, and select Duplicate.

3. In the Duplicate Rule Set dialog box, specify the following information:

   • New Rule Set Name: Enter a name for the new rule set.

     The name for the duplicated rule set must be unique. You cannot have two rule sets with the same name in a model.

   • Duplicate Rules: Select to duplicate all the rules in the source rule set into the new rule set.

   • Prefix for Rule Names: If you selected to duplicate rules, enter a prefix to use for the new rule names that will be created as part of the copy operation.

     Since you cannot have rules with the same name in a single model, the prefix is to ensure that each copied rule has a unique name.

4. Click Duplicate.

   The duplicated rule set is displayed under the rule set that was duplicated. The new rule set is initially created with the same sequence number as the source rule set. To change the sequence (the order in which the rule set will run), click next to the new rule set, and select Edit Row.