1. Oracle X9 Series Servers Administration Guide
  2. Configuring Storage Resources
  3. Configuring iSCSI Virtual Drive Properties
  4. Configure iSCSI Virtual Drive Properties (BIOS)

Configure iSCSI Virtual Drive Properties (BIOS)

iSCSI virtual drives are used primarily to run supported operating systems that reside on an external server and that function as the local server host operating system.

iSCSI virtual drives must be configured in the UEFI BIOS Setup Utility iSCSI screens.

Ensure that the following prerequisites are met:

  • You are familiar with iSCSI theory of operation and with iSCSI server setup procedures.

  • You have verified that iSCSI targets can be mounted on a client. Review the operating system documentation for more information.

  • You have access to an external iSCSI server running on a supported operating system.

  1. Access the BIOS Setup Utility.

    For instructions, see Using UEFI and the BIOS Setup Utility.

  2. Navigate to the Advanced menu.
  3. Select iSCSI Configuration.
  4. Select iSCSI Initiator Name, and then specify the iSCSI initiator name in iSCSI Qualified Name (iqn) format, for example iqn.1988-12.com.oracle:0010e02e458f.
  5. Select Add an Attempt.
  6. To connect to an iSCSI virtual drive, select the network adapter MAC address configured in the iSCSI server (ISID), for example 0010e02e458f.
  7. On the iSCSI screen, perform the following steps:
    1. Set the iSCSI Mode property to Enabled.
    2. Set the Internet Protocol property to IPv4.
    3. Set the Connection Retry Count property to 1.
    4. Set the Enable DHCP property to Enabled or Disabled to specify an addressing method for the iSCSI initiator.
    5. If you set the Enable DHCP property to Disabled, specify the Initiator IP Address, Initiator Subnet Mask, and Gateway.

      Note:

      Use the same subnet.
    6. Set the Get Target Info Via DHCP property to Enabled or Disabled to specify an addressing method for the iSCSI target.
    7. If you set the Get Target Info Via DHCP property to Disabled, specify the Target IP Address, Target Port, and Boot LUN.

      Note:

      When iSCSI is enabled on a network port, PXE is disabled for that port.
    8. Specify the Target Name in iSCSI Qualified Name (iqn) format, for example iqn.1988-12.com.oracle:XN-N-target.
    9. Set the Authentication Type property to CHAP (Challenge-Handshake Authentication Protocol) or None.
    10. Select Save Changes.
  8. Press the F10 function key to save your changes, exit the BIOS Setup Utility, and reboot the server.

    Note:

    The newly configured iSCSI drive does not appear in the BIOS boot list until after you install an operating system.