Prepare the Server for Hot Service (Oracle ILOM CLI)

This procedure describes how to prepare the server to remove, replace, or install hot-service components. A hot-service component can be serviced while the server is operating at Main power mode. For more information about component serviceability, see Component Serviceability Requirements.

Log in to the SP Oracle ILOM CLI.

Log in as a user with root or administrator privileges. For example, open an SSH session, and at the command line type:

ssh root@ ipaddress

Where ipaddress is the IP address of the server SP.

See Using Oracle Integrated Lights Out Manager (ILOM) in Oracle Server X8-8 Installation Guide.

The Oracle ILOM CLI prompt appears: ->
Verify that the Power State is OFF:

At the prompt, type the following command:

-> stop /System
To turn on the Locate Button/LED, type the following command:

-> set /System/ locator_indicator=on

Note:

To turn off the Locator indicator, type: set /System/ locator_indicator=off.
Once at the service location, press the Locate Button/LED button to deactivate the indicator.

For more information, see Control the Locate Button/LED Locally.
Set up an ESD-safe space at the service location.

Set up a space where you can place components. See Electrostatic Discharge and Static Prevention Measures.
Perform hot-service removal and installation procedures on components.

See Servicing Components.