1. Oracle ILOM User's Guide for System Monitoring and Diagnostics Firmware Release 5.0.x
  2. Using the Command-Line Interface
  3. CLI Reference for Mapping Management Tasks to CLI Targets
  4. Host Diagnostic Tasks and Applicable CLI Targets

Host Diagnostic Tasks and Applicable CLI Targets

Use the following table to help identify the applicable CLI namespace targets for Oracle ILOM host diagnostic tasks.

For detailed information about host diagnostics, see the topics listed in the Related Information section that appears after the table.

Host Diagnostic Tasks CLI Properties on SP User Role Required

View or modify host diagnostic properties on an x86 server.

/HOST/diag state

  • enabled

  • disabled

  • extended

  • manual

  • set

To run and view diagnostics, launch the remote system console from the web interface, and then restart the server.

  • Reset and Host Control (r)

View or modify host diagnostic properties on a SPARC server.

/HOST/diag

  • error_reset_level

  • error_reset_verbosity

  • hw_change_level

  • hw_change_verbosity

  • level

  • max

  • power_on_level

  • power_on_verbosity

  • trigger

  • verbosity

  • set

SPARC host diagnostic properties vary from system to system. Use the Help command to determine which host diag properties are supported on your server. For example: help /HOST/diag

To issue the full CLI path for host diag from a multi-domain SPARC server, append /Servers/PDomains/PDomain_n to the beginning of the /HOST/diag target.

To run and view diagnostics, launch the remote system console from the web interface, and then restart the system.

  • Reset and Host Control (r)

View or modify SP diagnostic properties on M7 or T7 series SPARC servers.

/SP/diag

  • default_level

  • hw_change_level

To run and view diagnostics, launch the remote console from the web interface, and then restart the system.

  • Reset and Host Control (r)