1. Setup Guide
  2. Diagnostics Utility
  3. Performing an RS232 Loopback Test

Performing an RS232 Loopback Test

The RS232 LoopBack screen lets you perform a loopback test on a single port using an RS232 Self LoopBack Unit.

  1. Connect a serial loopback connector to a workstation COM port. You can also connect a serial cable between two COM ports.
  2. Select the output and input ports.
  3. Press Test Ports.
  4. Verify that the Tx Bytes field and the Rx Bytes field increments.
  5. Press Quit Test.

Parent topic: Diagnostics Utility