Cisco Meraki Poller

The Cisco Meraki Poller microservice polls topology and metric data from Cisco Meraki devices by API using an API key.

Cisco Meraki has an API rate limited to five calls per second per organization.

This microservice is part of the Discovery microservice pipeline. See Understanding the Discovery Pipeline in Unified Assurance Concepts for conceptual information.

You can enable redundancy for this microservice when you deploy it. See Configuring Microservice Redundancy for general information.

Cisco Meraki Poller Prerequisites

Before deploying the Cisco Meraki Poller microservice, confirm that the following prerequisites are met:

1. A microservice cluster is set up. See Microservice Cluster Setup.

2. The following microservices are deployed:

   • Pulsar

   • Metric Sink

3. (Optional) You have created a Kubernetes secret containing the proxy certificates by running the following command as the assure1 user:

   export NAMESPACE=<namespace>
   a1k create secret generic meraki-proxy-secret --from-file=<PROXY_CA_FILE> --from-file=<PROXY_CRT_FILE> --from-file=<PROXY_KEY_FILE> -n $NAMESPACE 
   

   where <namespace> is the namespace where you are deploying the microservice. The default namespace is a1-zone1-pri, but you can change the zone number and, when deploying to a redundant cluster, change pri to sec.

   You can optionally use a different name for the secret files. If you do so, set them in the configData.PROXY_CA_FILE, configData.PROXY_CRT_FILE and configData.PROXY_KEY_FILE configuration parameters when you deploy the microservice.

Deploying Cisco Meraki Poller

To deploy the microservice, run the following commands:

su - assure1
export NAMESPACE=<namespace>
export WEBFQDN=<webFQDN> 
a1helm install <microservice-release-name> assure1/cisco-meraki-poller -n $NAMESPACE --set global.imageRegistry=$WEBFQDN

In the commands:

• <WebFQDN> is the fully-qualified domain name of the primary presentation server for the cluster.

• <microservice-release-name> is the name to use for the microservice instance. Oracle recommends using the microservice name (cisco-meraki-poller) unless you are deploying multiple instances of the microservice to the same cluster.

You can also use the Unified Assurance UI to deploy microservices. See Deploying a Microservice by Using the UI for more information.

Changing Cisco Meraki Poller Configuration Parameters

When running the install command, you can optionally change default configuration parameter values by including them in the command with additional --set arguments. You can add as many additional --set arguments as you need.

For example:

• Set a parameter described in Default Cisco Meraki Poller Configuration by adding --set configData.<parameter_name>=<parameter_value>. For example, --set configData.LOG_LEVEL=DEBUG.

• Enable redundancy for the microservice by adding --set redundancy.enabled=true.

Default Cisco Meraki Poller Configuration

The following table describes the default configuration parameters found in the Helm chart under configData for the Cisco Meraki Poller microservice.