OCSLB Configuration for IMS-AKA and TLS Traffic

The user makes the settings below to the applicable cluster-config element on the Oracle Communications Subscriber-Aware Load Balancer (OCSLB) to support IMS-AKA and TLS traffic. These setting allow this support by preventing the OCSLB from restricting the type of traffic supported by the cluster.

From superuser mode, use the following ACLI command sequence to access the cluster-config element.

ORACLE# configure terminal
ORACLE(configure)# session-router
ORACLE(session-router)# cluster-config
ORACLE(cluster-config)#service-ports
ORACLE(service-port)#

Use the port parameter to specify the port monitored by the OCSLB for incoming signaling messages.
The required setting for IMS-AKA or TLS is 0.
```
ORACLE(service-port)# port 0
ORACLE(service-port)#
```
Use the protocol parameter to choose the transport protocol.
The required setting for IMS-AKA or TLS is ALL.
```
ORACLE(service-port)# protocol ALL
ORACLE(service-port)#
```
Use done, exit, and verify-config to complete configuration of this tunnel-config configuration element.
Use done, exit, and verify-config to complete configuration of the OCSBC ims-aka-profile.