1. Configuration Guide
  2. RTC Support

A RTC Support

This appendix summarizes real-time configuration (RTC) support status for the Oracle Communications Session Border Controller . The table below lists which configuration elements are supported by RTC and which are not.

ACLI Configuration Elements Parameter Details
Access Control The access-control configuration object is partially supported by RTC.

Specifically, you can add and delete static ACLs without rebooting. Modifying existing static ACLs, reaching ACL capacity, or fixing configuration typos, however, require a reboot.
Accounting Config N/A
Authentication N/A
Certificate Record N/A
Class Profile N/A
Codec Policy N/A
DNS ALG Service N/A
DNS Config N/A
Enum N/A
External Policy Server N/A
External Policy Server The following H.323 stack subelement parameters are not RTC supported in that, if you save and activate a configuration, calls already in progress are dropped and a reboot is required:
  • state
  • isgateway
  • realm-id
  • assoc-stack
  • options
  • proxy-mode
  • local-ip
  • max-calls
  • max-channels
  • registration-ttl
  • terminal-alias
  • prefixes
  • ras-port
  • q931-port
  • auto-gk-discovery
  • multicast
  • gatekeeper
  • h245-tunneling
  • gk-identifier
  • alternate-transport
  • q931-max-calls
  • filename
H.323 The following H.323 stack subelement parameters are not RTC supported in that, if you save and activate a configuration, calls already in progress are dropped and a reboot is required:
  • q931-start-port
  • q931-number-ports
  • dynamic-start-port
  • dynamic-number-ports
IPSEC N/A
IWF N/A
Licensing N/A
Local Policy N/A
Local Response Map N/A
Local Routing Config N/A
Media Manager The Media Manager element is supported with the exception of the following parameters:
  • red-flow-port
  • red-max-trans
  • red-sync-start-time
  • red-sync-comp-time
Media Policy N/A
Media Profile N/A
Network Interface N/A
Net Management Control N/A
Network Parameters The Network Parameters element is supported with the exception of the following parameters:
  • SCTP parameters
NTP Sync N/A
Packet Trace Config N/A
Q850 SIP Map N/A
Realm Config N/A
Redundancy Config The Redundancy Config element is supported with the exception of the following parameters:
  • state
  • port
  • cfg-port
  • cfg-max-trans
  • cfg-sync-start-time
  • cfg-sync-comp-time
Session Agent N/A
Session Group N/A
Session Router N/A
Session Constraints N/A
Session Translation N/A
SIP Config The SIP Config element is supported with the exception of the following parameters:
  • red-sip-port
  • red-max-trans
  • red-sync-start-time
  • red-sync-stop-time
SIP Feature N/A
SIP Interface The SIP Interface element is supported with the exception of the following parameters:
  • collect, boot-state
SIP Manipulation N/A
SIP NAT The SIP NAT element is supported with the exception of the following parameters:
  • ext-address
SIP Response Map N/A
SNMP N/A
Static Flow N/A
Steering Pool N/A
Surrogate Agent N/A
System The System Config element is supported with the exception of the following parameters:
  • options
Test Pattern Rule N/A
Test Policy N/A
Test Translation N/A
TLS Global When configured to support MSRP over TLS, this configuration element is not RTC enabled. If a single TLS profile is used by both SIP and MSRP, RTC changes are applied for the SIP TLS configuration only.
TLS Profile N/A
Translation Rules N/A
Trap Receiver N/A