http-server
This element is reserved for future use. Use the http-server configuration element to provision the Oracle Communications Session Border Controller (OCSBC) for mid-call updates.
Parameters
- name
- Set the name of this HTTP server.
- state
- Enable or disable this HTTP server. Default: Enabled.
- realm
- Set the name of the realm on which to listen. The OCSBC uses management when you do not specify a realm.
- ip-address
- Set the local Host Identity Protocol (HIP) IP address on which to listen.
- inactivity-timeout
- Set the inactivity timeout length in minutes. Default: 5. Valid values: 0-20.
- http-state
- Enable or disable the HTTP connection. Default: Enabled.
- http-port
- Set the port number to use for the HTTP connection. Default: 80. Valid values: 1-65535.
- https-state
- Enable or disable the https connection. Default: Disabled.
- https-port
- Set the port number to use for the HTTP connection. Default: 443. Valid values: 1-65535.
- tls-profile
- Set the TLS profile that you want this server to use.
- auth-profile
- Set the authentication profile you want this server to use.
Path
http-server is an element under the System path. The full path from the topmost ACLI prompt is:configure terminal > system > http-server.
Note:
This is a multi-instance element.