ACLI Show Commands for TDM

9 ACLI Show Commands for TDM

Time Division Multiplexing (TDM) uses a unique set of ACLI "show" commands to provide information about the TDM configuration and its operations.

The following TDM "show" commands work only on the Acme Packet 1100, Acme Packet 3900, and Acme Packet 3950 platforms with a TDM card installed. No other Oracle® Enterprise Session Border Controller platforms recognize the TDM "show" commands. Oracle recommends using show commands for troubleshooting, and only with guidance from Oracle support technicians.

show running-config tdm-config

Displays the tdm-config element, which is located under system.

show running-config tdm-profile

Displays the tdm-profile sub-element, which is located under tdm-config.

show tdm spans

Displays the following states for TDM spans:

Active—The span is powered.
Down—The span is not connected.
In alarm—The connected span is down.
Up—The span is connected.

show tdm <span # >

Displays the state and configuration profile of a specified span.

show tdm channels

Displays the following information about the TDM channels:

Context—Incoming TDM calls = from-pstn. Outgoing TDM calls = from-sbc.
State—The status of the TDM channels, for example, In Service.

show tdm channel #

Displays the profile of the specified channel.

show tdm status

Displays the enablement status of State and Logging, plus the TDM profile.

show tdm dialplan

Displays the TDM dial plan.