Setting the Initial Configuration

You can initialize the Oracle Enterprise Communications Broker Communications Broker) from both the ACLI and the GUI, but you must use the ACLI first. You initialize the Communications Broker from the ACLI using the run setup command.

Immediately after installation, setting passwords, running setup product and running setup entitlements from the ACLI, perform the run setup procedure from the ACLI. This sets basic system elements, including the GUI, by answering a series of questions. Questions provide a default value that you can accept to enable reliable and consistent system connectivity. After completing run setup, use the Web GUI to configure the Oracle Enterprise Communications Broker (Communications Broker).

Note:

ACLI output sometimes refers to System Operations, including the setup product operation using the common term, wizard.

The run setup process initializes or configures the following:

  • Management IP address and Gateway IP address
  • Web GUI
  • High Availability settings
  • Communications Broker access setting

You can perform this task after installation from either the ACLI or the GUI.