Initializing with Run Setup

Use the following procedure to initialize the OECB so you can configure using the OECB Web GUI.

  1. In Superuser mode, type run setup, and press Enter.
    ORACLE# run setup

    Note:

    The run setup quiet command, which enables a less verbose presentation, also initializes the OECB.

    The following displays.

    =========================================================
    -----------------------------------------------------------
    Thank you for purchasing the Oracle ECB. The following
    short wizard will guide you through the initial set-up.
    -----------------------------------------------------------
    '?' = Help; '.' = Clear; 'q' = Exit
    
    CONFIGURATION
    
    WARNING: Proceeding with wizard will result in existing configuration being erased.
      Erase config and proceed (yes/no) [no]               :
    =========================================================

    You can use:

    • ?’ key to obtain query-specific help
    • .’ key to clear the field of the current setting.
    • q’ key to exit the process. Initiating the q displays the following prompt:
      Discarding changes and quitting wizard. Are you sure? [y/n]?:
      Enter y to discard any changes and quit the installation . The root prompt displays.

    A “Warning” displays stating that using run setup overwrites the existing running configuration. If you want to back out of the setup process and not overwrite the current running configuration, you can enter q or enter No at the Erase config and proceed prompt. The root prompt displays.

  2. The system offers you the opportunity to establish an HA deployment. Proceed with your setup.
  3. The system offers you the opportunity to create a unique target name, which the system requires. Proceed with your setup.
  4. The system offers you the opportunity to establish an management address. Proceed by setting the management address parameters. If you previously set these parameters, you can simply accept the existing settings.
    Management interface IP address [address]    :
      Management interface subnet mask [mask]             :
      Management interface gateway IP address [address]   :
      SIP interface VLAN id (0 - 4095) [0]                :
    
  5. Depending on your command syntax, run setup or run setup quiet, the system offers you the opportunity to set a SIP interface, timezone, specify the number of licensed sessions, and so forth. Follow the prompts to continue the setup process, and press Enter.
  6. Your setup sequence provides you with the opportunity to save these settings.
    Enter 1 - 27 to modify, 'd' to display summary, 's' to save, 'q' to exit. [s]:

    When you proceed with saving, the following displays.

    Saving changes and quitting wizard. System will reboot. Are you sure?  [y/n]?:

    -’ key to navigate to the previous step in the setup process, if required, and change your response.