1. Administrator's Guide
  2. Applicable Platforms
  3. Log On to the System

Log On to the System

The Oracle Enterprise Communications Broker (OECB) requires you to set passwords for the Admin and User accounts the first time you power up a new or factory reset system by way of local access. You cannot access the Admin and User accounts until you set the corresponding passwords. Use either an SSH connection or console connection when setting passwords. You can log on to the system after setting passwords.

Before you begin, plan your passwords to meet the following requirements:
  • 8-64 characters
  • Include three of the following:
    • Lower case letters
    • Uppercase letters
    • Numerals
    • Punctuation

The system leads you through the process for setting the Admin and User passwords, as follows:

  1. Power up the OECB.
    The system prompts you to set the User account password.
  2. At the prompt, type acme, and press ENTER. The system prompts you to enter the password that you want for the User account.
  3. Set your User account password, and press ENTER.
  4. Type enable, and press ENTER.
    The system prompts you to set the Admin account password.
  5. Type packet, and press ENTER.
    The system prompts you to enter the password that you want for the Admin account.
  6. Set your Admin account password, and press ENTER.
    The system logs you in as Admin.
  7. Type setup prod, and press ENTER.
  8. Type 1, and press ENTER.
  9. Type 5, press ENTER, and save.
  10. Type setup entitlements, and press ENTER.
  11. Type 1, and press ENTER.
  12. Set the Session Capacity from 0-32000, press ENTER, and save.
  13. Type run setup, and press ENTER. This initializes the product and configures, for example, the HTTP Server object for using the GUI.
    See Setting Up System Basics for a complete description of the run setup command and its equivalent Set Initial Configuration system operation.
  14. Access the GUI using the configured management address to proceed with further configuration.