Web Server Settings

Configure your preferences for the Oracle Enterprise Communications Broker (OECB) web server in the Server Settings page.

Note:

The HTTP state and HTTPS state parameters may have already been set via the GUI installation wizard on your Oracle Enterprise Communications Broker. You can edit these parameters if required.

Access the Web Server Settings configuration object.
Configuration, System Administration, Web Server Settings.

On the Server Settings page, do the following:

Inactivity Timeout

Enter the amount of time, in minutes, that the Web GUI must have remained inactive before it ends the Web session. For example, if this timeout value is set as 5, after 5 minutes of no activity, the Web session disconnects. Default is 10. Valid values are 0 to 20. Zero (0) disables this parameter.

HTTP State

Specify whether or not to enable HTTP for accessing the Web server. Default is enabled. A check mark indicates enabled, and a blank box indicates disabled.

HTTP Port

Enter the port for the HTTP connection. Default: 80. Valid values: 1-65535.

HTTPS State

Specify whether or not to enable HTTPS (secure connection) for accessing the Web server. Default is disabled. A check mark indicates enabled, and a blank box indicates disabled.

HTTPS Port

Enter the port for the HTTPS connection. Default: 443. Valid values: 1-65535.

TLS Profile

Enter the Transport Layer Security (TLS) Protocol profile name to use with HTTPS. Valid values: Alpha-numeric characters. Default: Blank.

Note:

If you specify a TLS profile, and HTTP is enabled, the OECB checks against the TLS profile table for a match. If there is no match, the applicable errors display during the verification of the configuration.

Click OK.
Save the configuration.