1. Administrator's Guide
  2. Applicable Platforms
  3. HA Cabling
  4. Cable a Single Rear Interface for HA

Cable a Single Rear Interface for HA

The following procedure explains how to cable a Netra Server X3-2 for Acme Packet High Availability (HA) node using single rear interface support.

  1. Insert one end of an Ethernet cable into wancom1 on the rear panel of Netra Server X3-2 for Acme Packet #1. The release tab on the RJ-45 jack clicks into place when you insert it properly.
  2. Insert the other end of the Ethernet cable into the corresponding management interface on the rear panel of the Netra Server X3-2 for Acme Packet #2 as shown in the following illustration. For example, If you use wancom1 on Netra Server X3-2 for Acme Packet #1, then you connect it to wancom1 on Netra Server X3-2 for Acme Packet #2.
    This illustration shows the cable connection between the wancom 1 ports on two Netra X3-2 for Acme Packet devices in an HA pair.

    HA Node Using Single Rear Interface Support (No Quad GigE NIC)

Refer to the configuration procedures located in the HA Nodes information in the Configuration Guide.