1. Administrator's Guide
  2. Applicable Platforms
  3. Cabling the Netra Server X3-2 for Acme Packet
  4. Cable ILOM

Cable ILOM

The following procedure explains how to make a connection to the Netra Server X3-2 for Acme Packet Integrated Lights Out Management (ILOM)port. For a remote permanent connection to the SP over the ILOM connection, use the rear panel NET MGT port.

Refer to the Netra Server X3-2 for Acme Packet hardware documentation for information on how to configure your Web browser application to connect to the console, and how to establish communications with the Netra Server X3-2 for Acme Packet.

Caution:

Keep Ethernet cables separated from power cables by at least 60mm where possible and never run them in the same channel of the rack without segregation.

Prerequisites:

  • Category 6 (or better) Ethernet cable with RJ-45 jacks
  1. Locate the cable to connect to the Netra Server X3-2 for Acme Packet.
  2. Plug the RJ-45 connector into the ILOM port. This illustration shows the location of the ILOM port on the back panel of the Netra Server X3-2 for Acme Packet.
  3. Lead the cable away from the rear panel, and connect the other end of the cable to the LAN.