Acronyms

The following table provides information about the acronyms and the terminology used in the document:

Table - Acronyms

Acronym Description
AS Associate State
BOC Bit Oriented Code
CDL Command Driven Loopback
CI Clock Input
CSV Comma Separated Value
DCM Database Communications Module
DPC Destination Point Codes
DSM Database Services Module
DUT Device Under test
DVM Digital Volt/Ohm Meter
EDCM Enhanced Database Communications Module
EMDC Element Measurement & Data Collection
EPAP EAGLE Provisioning Application Processor
ESD Electrostatic Discharge
FAP Fuse and Alarm Panel
FD CRNT Fixed Disk Current Partition
FTA File Transfer Area
GPL Generic Program Loads
IMP Interprocessor Message Transport
IPMX Interprocessor Message Transport Power and Multiplexer
LBF Load Balance Factor
LFS Link Fault Sectionalization
LIM Link Interface Module
LSMSSS Local Services Management System Subsystem
MAS Maintenance and Administration Subsystem
MASP Maintenance Administration Subsystem Processor
MCA Matrix Controller Automatic
MCPM Measurement Collection and Polling Module
MIS Maintenance Interface System
MPS Multi-Purpose Server
MRN Message Reference Number
NDCSS Network Data Collection Subsystem
PST Primary State
RMA Return of Material Authorization
RMC Remote Maintenance Center
SCMMA State Change due to Manual Action
SCP Signaling Control Point
SLC Signaling Link Code
SLIC Service and Link Interface Card
SST Secondary State
STP Signal Transfer Point
TFP Transfer Prohibited
TFR Transfer Restricted
TOCA Timing Output Composite Automatic
UAM Unsolicited Alarm Messages
UIM Unsolicited Information Messages