Network Management Ports

Standard shielded CAT5e or CAT6 (or higher) Ethernet cables with RJ45 jacks are used for connecting the Acme Packet 6400 management Ethernet ports to your network. These ports support 10/100/1000 Mbps speeds.

Note:

Keep Ethernet cables separated from power cables by at least 60mm where possible and never run them in the same channel of a trunking system without segregation.
  1. Insert the RJ45 connector on the end of the Ethernet cable into one of the management Ethernet ports. These ports are labeled MGT0, MGT1, and MGT2. The release tab on the RJ45 jack will click into place when inserted properly.
  2. Route the cable away from the Acme Packet 6400. Make sure that the Ethernet cables are not stretched tightly or subject to extreme stress.