Reinstall the Server Into the Rack

After servicing the system, reinstall it into the rack.

Caution:

Deploy any rack anti-tilt mechanisms before installing the server into the rack.

Caution:

The server weighs approximately 76 lbs (34 kg). Two people are required to carry the chassis and install it in the rack.

Use a mechanical lift or two people to transport the chassis and install it in the rack.

Lift the server from the antistatic mat, and reinstall the server into the rack.

See Rackmounting the Server.
If the cable management arm (CMA) is not installed, because you removed the server completely out of the rack, install the CMA.

See Install the Cable Management Arm (Optional).
If the cables are disconnected from the back of the server, because you removed the server completely out of the rack, reconnect the cables.
- For instructions to reconnect cables to the back of the server, see Reconnect Power and Data Cables.
- To identify the location of cable connectors on the back of the server, refer to Back Panel Connector Locations.