Description of the illustration obins013.gif

This screen shot shows the Configure: Defaults and Policies > Devices page.

There is a three-column table. Beginning at the left, the columns are labeled Name, Current Value, and Reset to Default Value. The Names and Current Value entries in the table are as follows:

• Check serial numbers

  The current value choices are in a list, currently set to "yes".

• Disable Async IO

  The current value choices are in a list, currently set to "no".

• Discovered device state

  The current value choices are in a list, currently set to "not in service".

• Disk Pool free space goal

  The current value choices are in a list, currently set to “10”.

• Error rate percentage

  The current value choices are in a list, currently set to "8".

• Max ACSLS Eject Wait Time

  The current value is a field, currently showing "5", and a units list, currently set to "minutes".

• Max Drive Idle Time

  The current value is a field, currently showing "5", and a units list, currently set to "minutes".

• Return to service check

  The current value choices are in a list, currently set to "no".

At both the top and bottom of the table are three buttons. From left to right, they are Apply, OK, and Cancel.