| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Switch ES1-24 Installation Guide |
Understanding the Installation
Understanding Management and Power Cabling
Management Connection Overview
Single-Switch Location Guidelines
Attach the Rails to the Switch
Attach Telco Adapters to the Rack Slides
Attach the Rack Slides to the Rack
Install the Switch Into the Rack
Install the Air Duct and Front Support
Attach Data and Management Cables
Prepare the Front Support and Small Air Duct
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From the CLI (SER MGT)
Log Into the Oracle ILOM Web (NET MGT)
Log Into the Oracle ILOM CLI (NET MGT)
The power supplies are in an N+N redundancy. Line power is provided from two sources, A and B.
The switch accessory kit should contain two power cords that are specific to your country or application. This table describes the power cords available.
 | Caution - Install and route power cabling only in a manner that complies with federal, state, and local electrical codes. |
|
|