TMADMIN Messages 400-499

473

ERROR: Error reading file filename

Description

An attempt to read a saved Bulletin Board failed.

Action

The BB may be the wrong size or corrupted, or the specified file may not be a saved BB.

See Also

tmadmin(1)

474

ERROR: Error setting auth type to CLIENT

Description

An attempt to open a saved Bulletin Board file failed.

Action

Check to see that the specified file exists and that you have read permission.

See Also

tmadmin(1)

475

ERROR: Error setting bb type to PRIVATE

Description

An attempt to attach to a saved bulletin board failed.

Action

Contact your BEA TUXEDO system Technical Support.

See Also

tmadmin(1)

476

ERROR: Error attaching to private bulletin board

Description

An attempt to attach to a saved bulletin board failed.

Action

Contact your BEA TUXEDO system Technical Support.

See Also

tmadmin(1)

477

ERROR: Error opening file filename

Description

An attempt to open a saved bulletin board failed.

Action

Contact your BEA TUXEDO system Technical Support.

See Also

tmadmin(1)

494

ERROR: Cannot stop processes from non-master node

Description

The shutdown command invokes tmshutdown(1) to shut down processes. Because tmshutdown(1) needs access to the DBBL for successful processing, it must run on the master node (that is, where the DBBL resides).

Action

Consult the MASTER keyword of the RESOURCES section of the ubbconfig(5) file to determine your application's master node. This is the node on which tmadmin(1)'s shutdown command must be executed. Note that if the master command was previously executed, the DBBL may be running on the backup node instead. In this case, the shutdown command must be executed from tmadmin(1) running on the backup node.

See Also

tmadmin(1), tmshutdown(1), ubbconfig(5)

498

ERROR: The new value is not within the range of min-max

Description

This message is printed when an illegal value has been given to one of the changeload, changepriority, or changetrantime commands of tmadmin(1). Service loads must be between 1 and 32767, inclusive; service priorities must be between 1 and 100, inclusive; and transaction times must be between 0 and 2,147,483,647, inclusive.

Action

Re-enter the command using a value within the appropriate range. The SERVICES section of the ubbconfig(5) manual page describes the correct ranges and defaults for these service attributes.

See Also

ubbconfig(5)

499

ERROR: Error changing value

Description

An error was encountered trying to update a service's priority with the changepriority command, or its transaction timeout value with the changetrantime command. This error may have occurred because of a communication failure between tmadmin(1) and the DBBL or one of the BBLs.

Action

Check the userlog(3c) file to see if a communication error occurred that caused the requested command to fail.